← Back to Forum

Sunrise ATA-IDE+RS232C Cartridge not working

Junior • May 30, 2013 at 21:15
I have 2 ATA-IDE + RS232C Sunrise interfaces , one is not working. This cartrdidge doesn't boot , and updating the flashrom is not possible. Is there somebody with repair ideas of these cartridges .

Replies (4)

nrgo • May 30, 2013 at 22:59
Why is not possible to update firmware? Don't you have a MSX with a floppy disk drive? Maybe it's possible via cassette port.
Junior • May 30, 2013 at 23:22
Because the software comes with the message No IDE system installed during startup. It's not possible to boot in DOS 2.20 that's build in the cartridge .
nrgo • Jun 01, 2013 at 12:59
Heve you tried to boot this configuration: - MSX with MSX-DOS 1 and IDE BIOS flashing utilities on floppy disk; - IDE+RS232 cart inserted in slot 1; - during boot press INS (or GRPH, don't remember...) to boot MSX-DOS 1. If MSX-DOS 1 boots, then flash IDE bios into the IDE cart.
Junior • Jun 02, 2013 at 00:06
Msx comes with the message Flashrom:test failed , so i think there's a hardware failure .

Please login to reply to this thread.

Last Viewed